GeneXpert System Quiz

The client has moved the GeneXpert from one laboratory to another and when reconnecting everything, it calls indicating that THE MODULES ARE NOT DETECTED. Why could this happen?

• The network adapter for the connection with GeneXpert has been disabled

• You have connected the GeneXpert network cable to the wrong port on the PC

• Both could be correct

When doing a PC replacement (old PC still accessible), what sequence of steps would be the fastest and most effective to configure the Gx Dx?

• 1. 1. Make a backup of the database

  2. 2. Convert the DB to the proper version (if required)

     3. 3. Restore it on the new PC

• 1. 1. Take photos of all configuration (LIS settings, installed ADFs, test codes)

  2. 2. Archive all run files (patient data)

  3. 3. Configure the new PC and import results

• 1. 1. Ask customer to provide list of Users

  2. 2. Ask LIS vendor to provide Host Configuration Settings

  3. 3. Reconfigure new PC with collected info

Visiting the laboratory, they tell us that there is a connection problem in the GeneXpert in relation to BT. The user also tells us that he is connected to the LIS and that he correctly transmits all the tests. What could be the origin of the failure in the BT? (2 Correct answers)

• A proxy misconfiguration

• A misconfiguration of the GeneXpert PC IP

• That the client has disconnected the network adapter

• A block in the firewall

You want to perform a Database Backup but some tests are running... can you perform this action?

• Yes, close the program and click on YES (to Database Management Task, Database Backup)

• No, you need to wait until the test is finished, close the program and click on YES (to Database Management Task, Database Backup)

• Yes, go to 'Archive Results', 'Select all' and save the file

What data do we need from IT to connect a computer to the network?

• IP + MAC + proxy + DNS

• port + IP + LIS codes

• IP + Subnet Mask + Default Gateway + DNS

If the IP address given by the LIS provider and a port are configured in the LIS Host settings of the GeneXpert software, it means that GeneXpert acts as:

• client

• server

• client and server interchangeably

You have followed all the steps of the protocol correctly to replace a PC with connection to LIS, using new usb cables and adapter but the PC does not connect to the network, what could be happening?

• You need to update the SW version of the GX

• the IP address is associated with the MAC address of the network adapter

• The IT technician has not registered the new SN of the equipment in the Hospital database

You are performing a PC replacement and when you try to restore database, the following message pops up: 'Database restore was unsuccessful'. What can I do to successfully restore the database?

• Use the Database Backup File Generator Utility and convert the Database to a valid format for the new Dx version present on new PC

• Make a software upgrade (Dx same as installed on new PC) on old PC, create a Database Backup and restore that Backup on new PC.

• A and B are correct

What transmission protocols are possible options for Cepheid systems (Infinity,GeneXpert or GeneXpert TS ?

• HLA, FTP and POC

• HL7, ASTM and POCT1-A

• HL7, FHIR and RS232

I want to perform a Database Backup but when I close the software the notification: 'Do you want to perform Database Management Tasks?' does not pop up. What can I do to activate this notification?:

• Go to 'Setup', 'System Configuration', 'Archive Settings', 'Manually with reminder' (daily)

• Go to 'Data management', 'Archive', 'Select all' and save the file

• Go to 'Setup', 'System Configuration', activate 'Database Management Reminders'