4 cocu 11

How to detect damage to clutch elements?12345

• By performing a stall test for automatic transmission

• By replacing the transmission/transaxle filter

• By checking the oil sump automatic transmission nat

• By inspecting the torque converter stator

What is the function of a job card?

• To replace the transmission/transaxle filter

• To perform a pressure test for automatic transmission

• To secure the unit with a strap

• To provide information about the service center and customer

What should be done before refilling automatic transmission fluid?

• Secure the unit with a strap

• Replace the transmission/transaxle filter

• Inspect the torque converter before installation

• Check the level of ATF for each automatic transmission unit

What is the purpose of a stall test for automatic transmission?12345

• To ensure the ATF reaches the normal operating temperature

• To inspect the torque converter stator and transmission clutch condition

• To determine the maximum engine speed achieved at full throttle

• To check for leaks at the bottom of the automatic transmission

What should be done before installing the transmission/transaxle unit?12345

• Ensure the shifter level is in the PARK or NEUTRAL position

• Replace the transmission/transaxle filter

• Check and tighten the oil pan bolts

• Perform a pressure test for automatic transmission

What is the pre-installation step for the torque converter?

• Connect the pressure test plug to the pressure gauge

• Inspect the flexplate and driveshaft

• Check the level of ATF for each automatic transmission unit

• Replace the transmission/transaxle filter

What should be done after installing the transmission/transaxle unit?12345

• Replace the transmission/transaxle filter

• Check and tighten the oil pan bolts

• Perform a stall test for automatic transmission

• Connect the pressure test plug to the pressure gauge

What is the purpose of the pressure test for automatic transmission?12345

• To determine the maximum engine speed achieved at full throttle

• To inspect the torque converter stator and transmission clutch condition

• To ensure the ATF reaches the normal operating temperature

• To check the specified values for each range (D, 2, L, R)

What should be done during the stall test for automatic transmission?12345

• Check the ATF level and ensure it reaches the normal operating temperature

• Depress the accelerator pedal to the maximum

• Place the gear lever in the PARK or NEUTRAL position

• Install an engine tachometer

What is the attachment procedure for the torque converter installation?12345

• Ensure the shifter level is in the PARK or NEUTRAL position

• Place the torque converter facing downward on a flat surface

• Connect the pressure test plug to the pressure gauge

• Replace the transmission/transaxle filter