Session 3 basic electrical 4

Session 3 basic electrical 4

Professional Development

10 Qs

quiz-placeholder

Similar activities

Session 3 test prep 1

Session 3 test prep 1

Professional Development

10 Qs

ASK Team quiz 1

ASK Team quiz 1

10th Grade - Professional Development

15 Qs

Multimeter Basics Quiz

Multimeter Basics Quiz

Professional Development

10 Qs

Analog to digital converter

Analog to digital converter

Professional Development

10 Qs

Types of overcurrent and protective devices in AC systems

Types of overcurrent and protective devices in AC systems

Professional Development

10 Qs

AES - Electrical System

AES - Electrical System

KG - Professional Development

15 Qs

RSM - KLL

RSM - KLL

Professional Development

10 Qs

29-04-20

29-04-20

KG - Professional Development

8 Qs

Session 3 basic electrical 4

Session 3 basic electrical 4

Assessment

Quiz

Professional Development

Professional Development

Hard

Created by

Mike Berezowsky

Used 6+ times

FREE Resource

10 questions

Show all answers

1.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

What is 'ghost voltage' an indicator of?

An open circuit

A short to ground

A short to power

A faulty meter

2.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

As the number of resistors decreases in a parallel circuit

Total resistance decreases

The current flow increases

The voltage-drop increases

Total resistance increases

3.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

If an insulated wire rubbed through a part of the insulation and the wire conductor touched the steel body of a vehicle, the type of failure would be called a(n) ________.

short-to-voltage

short-to-ground

open

chassis ground

4.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

If 200 amperes flow from the positive terminal of a battery and operate the starter motor, how many amperes will flow back to the negative terminal of the battery?

Cannot be determined

Zero

About one-half (about 100 amperes)

200 amperes

5.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

What would happen if a chosen wire gauge was too small (higher gauge) than required?

The fuse would "blow"

The wire would remain cool

The wire would become hot when the circuit is "off"

The wire would become hot when the circuit is "on"

6.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

During a starter cable voltage drop test, what is an acceptable voltage reading?

12.0 volts

0.3 volts

9.6 volts

1.5 volts

7.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Kirchhoff's Law for current states

One Volt will push one Amp through one Watt

The current flowing into any junction of an electrical circuit is equal to the current flowing out

Low resistance loads will have a large voltage drop and increased current flow through each load

High resistance loads require more current to move through the loads

Create a free account and access millions of resources

Create resources
Host any resource
Get auto-graded reports
or continue with
Microsoft
Apple
Others
By signing up, you agree to our Terms of Service & Privacy Policy
Already have an account?

Discover more resources for Professional Development