Module 00103-15 Exam

1. Another name for a machinist's hammer is _____.

• ball-peen hammer

• claw hammer

• veneer hammer

• skedgehammer

2. A heavy-duty tool used to drive posts or other large stakes is a _____.

• mallet

• sledgehammer

• bell-faced hammer

• ball-peen hammer

3. The proper angle for the edge of a cold chisel is _____.

• 90 degrees

• 60 degrees

• 45 degrees

• 30 degrees

4. The type of screw shown in the figure above is a(n) _____.

• Phillips head

• TORX

• Allen

• Robertson

5. Which of the following screws comes to a relatively sharp point at the base of its drive socket?

• Reed and Prince

• TORX

• Allen

• slotted

6. How many sides does a hexagonal shape have?

• 4

• 5

• 6

• 7

7. In what way is a spud wrench different from a pipe wrench?

• It is not adjustable,

• It has smooth jaws.

• It is significantly shorter.

• Using an extension handle is recommended.

8. To quickly run a nut onto a bolt that resists spinning it on with the fingers, you can drive the socket with a(n) _____.

• striking wrench

• open-end wrench

• speed handle

• breaker bar

9. Another common name for lineman pliers is _____.

• locking pliers

• tongue and groove pliers

• needle-nose pliers

• side cutters

10. Because of its stiffness, a folding rule is better than a cloth or steel tape for measuring _____.

• vertical distance

• horizontal distance

• inside dimensions

• circular diameters