15 SAFETY TEST: Drill Press

Check the ____________ setting to see that it is correct for your work.

• speed

• default

Holes over ½” should be bored at the ____________ speed.

• fastest

• slowest

Use only an approved type of bit. Bits with __________ __________ should not be used.

• feed screw

• sharp edges

Remove the __________ __________ immediately after tightening the bit.

• chuck key

• drill bit

When using ____________ diameter bits, always clamp the material to the table. Small or irregular shaped pieces must also be clamped.

• large

• small

Make sure a ____________ piece of wood is placed under your stock when the holes will go all the way through.

• scrap

• thin