Disc Sander Safety and Usage Quiz

What is the primary function of the reference table on a disc sander?

• To hold the motor shaft

• To secure the abrasive disc

• To support the workpiece

• To measure the diameter of the disc

Where should you always sand on the disc sander?

• On the upward-traveling side of the disc

• On the downward-traveling side of the disc

• On the left side of the disc

• On the right side of the disc

What is the common diameter of the disc on a disc sander?

• 10 inches

• 12 inches

• 14 inches

• 16 inches

How close can your fingers be to the abrasive when sanding stock?

• Within 1 inch

• Within 2 inches

• Within 3 inches

• Within 4 inches

What should you do to avoid overheating the abrasive material?

• Apply excessive pressure

• Keep the stock moving

• Hold the stock still

• Use a different abrasive

What type of curves should you use the disc/belt sanders for?

• Inside (concave) curves

• Outside (convex) curves

• Both inside and outside curves

• Only straight edges

What should you ensure about the disc on the disc sander before use?

• It is clean

• It is properly secured

• It is new

• It is lubricated

What should you avoid using the sanders for?

• Sanding straight edges

• Sanding outside curves

• Joinery and squaring stock

• Sanding convex shapes

What is the purpose of applying moderate pressure to the stock against the abrasive?

• To ensure a smooth finish

• To prevent overheating and damage to the abrasive

• To make the process faster

• To hold the stock in place

What is included in a combination sander?

• A horizontal belt sander

• A vertical belt sander

• A circular saw

• A drill press