phase4mod8unsafe.

When an appliance is identified as Immediately Dangerous and the user will not allow the gas operative to disconnect the appliance, the gas operative must in all cases:

• Inform Gas Safe Register.

• Inform the Gas Transporter.

• Inform the local Authority.

• Inform the HSE.

A warning notice provides:

• An alternative to a 'Danger Do Not Use' label.

• Additional information regarding the unsafe situation.

• Documentation for the Gas Safe Register inspectors.

• A list of alternative Gas Safe Register Installers.

When an installation is found At Risk, where turning off will not remove the risk , the gas operative must:

• Fill in a warning notice, attach a 'Danger Do Not Use' Label, and turn installation off.

• Contact the Gas Transporter to disconnect the gas supply at the service.

• Raise a RIDDOR report to the HSE.

• Fill in a warning notice , do not attach a Danger Do Not Use label, advise the customer who to contact for further investigation.

When a gas operative identifies an installation that must be reported to RIDDOR, the report must be passed to:

• Gas Safe Register.

• The HSE.

• National Emergency Service

• The Local authority

When a warning notice has been complete the gas operative must:

• Issue both copies to the user.

• Retain one copy, and send one copy to the HSE.

• Issue one copy to the user and retain one copy.

• Issue one copy to the user and send one copy to HSE.

'Danger Do Not Use' Labels are used to:

• To warn the user of possible dangers.

• to warn the gas operative of possible dangers.

• Provide evidence that the gas operative has acted responsibly.

• Provide information to the HSE of a dangerous appliance/installation.

When a gas operative identifies an installation that must be reported under RIDDOR, the report must be submitted to the relevant body within:

• 1 week.

• 2 weeks.

• 1 month.

• 3 months.

If the correct warning notice is not fitted to a primary meter, the gas operative must inform:

• The occupier and/or landlord.

• The gas supplier.

• The Gas Transporter.

• There is no need to notify anyone.

The labels used for domestic Medium to low pressure meter installations state "This Installation is supplied with gas at"?

• 21bar.

• 2 bar.

• 21mb.

• 2mb.

Which one of the following is not required when performing a visual risk assessment on an appliance where has been no interruption to the gas supply?

• Check the ventilation is adequate.

• Inspect the appliance for any signs of distress.

• Perform a combustion analysis.

• Visually inspect the flue system