Introduction to Construction Final Exam

Which of the following operations would normally be done using a pneumatic stapler rather than a nailer?

• Constructing cabinets
• Installing finish work
• Installing framing
• Installing insulation

Specifications do all of the following except _____.

• serve as a guide for compliance with building codes
• define materials to be used
• clarify information that cannot be shown on the drawings
• replace the drawing notes

The dimension marked F in the figure represents a measurement made from _____.

• outside to center
• center to center
• outside to outside
• wall to wall

The electrical symbol marked C in the figure represents a _____.

• single-pole switch
• triplex receptacle
• three-way switch
• double-pole switch

The material symbol marked A in the figure represents _____.

• insulation
• concrete
• wood
• stone

The plumbing symbol marked D in the figure represents a _____.

• hose bib
• wall-hung toilet
• shower
• sink

The HVAC symbol marked E in the figure represents a _____.

• cold air return duct
• wall supply outlet
• warm air duct
• louver opening

The symbol marked B in the figure represents a _____.

• casement window
• fixed sash window
• double-hung window
• slider

A portable circular saw has _____.

• retractable lower and upper blade guards
• a retractable upper blade guard
• a fixed (non-adjustable) baseplate
• a retractable lower blade guard

Lines on drawings used to indicate an area that has been cut away and shown in a section view are called _____ lines.

• extension
• break
• cutting plane
• phantom