Tire Repair Quiz

What is the first step in the tire plug installation process?

• Apply the tire plug adhesive

• Inflate the tire to the recommended pressure

• Remove the tire from the vehicle

• Locate the puncture or leak in the tire

What tool is commonly used to ream out the puncture hole in the tire?

• Hammer

• Screwdriver

• Pliers

• Tire reamer

When inserting the tire plug, what should be used to ensure it goes in smoothly?

• Lubricant

• Water

• Super glue

• Sandpaper

What is the purpose of trimming the excess plug material from the tire?

• To ensure a secure and proper seal for the tire repair.

• To prevent the tire from holding air

• To make the tire heavier

• To improve the tire's grip on the road

What is the recommended pressure for inflating the tire after the plug installation?

• 100 psi

• Manufacturer's recommendation or tire pressure label on the vehicle's door jamb or in the owner's manual

• 50 psi

• 20 psi

What is the maximum speed recommended for a tire that has been repaired with a plug?

• 75 mph (120 km/h)

• 50 mph (80 km/h)

• 100 mph (160 km/h)

• 60 mph (96 km/h)

What is the best way to check if the tire plug installation was successful?

• Taste the air coming out of the tire for any abnormalities

• Listen for a hissing sound coming from the tire

• Smell the tire for any unusual odors

• Visually inspect the tire for leaks and check the tire pressure.

What are the potential risks of driving on a tire with a plug repair?

• Loss of tire pressure, tire blowout, and compromised tire integrity

• Increased vehicle stability

• Improved fuel efficiency

• Enhanced tire durability

What are the common causes of tire punctures that may require a plug repair?

• Alien abduction

• Lack of vitamin D

• Eating too much ice cream

• Common causes of tire punctures include sharp objects on the road, nails, screws, glass, and potholes.

What are the steps to properly patch a tire from the inside after a plug repair?

• Remove the tire from the wheel, clean the punctured area, apply a patch and adhesive from the inside, and then re-inflate the tire.

• Spray paint the punctured area

• Fill the tire with water to check for leaks

• Apply duct tape to the outside of the tire