Brakes ASE

A rotor that is machined on a car compensates for :

• Caliper wear

• Hub Flange Runout

• brake pad wear

• oversized drum

Machining a rotor on the car can save :

• brake pad wear

• labor time

• Hub wear

• wheel bearing play

A Vehicle pulls to the left While driving but pulls to the right when braking. What could be the cause?

• seized left front caliper

• seized right front caliper

• faulty wheel cylinder

• sized right caliper slide

The piston in a claiper is retrated by a :

• return spring

• square cut seal

• dust boot

• wheel cylinder

A front wheel bearing is discolored. What could be the cause?

• insufficient bearing grease

• misajusted bearing

• both of the above

• none of the above

when installing an axle nut during replacement of a sealed wheel bearing, The technician should:

• Tighten the axle until snug

• Tighten the axle nut with an impact wrench

• Tighten the axle nut then back it of

• tighten the axle nut then torque it.

what tool can be used to test a wheel speed sensor:

• A Digital multi-meter

• oscilloscope

• both of the above

• none of the above

What could cause the ABS warning lamp to illumiate on the dash?

• a faulty vehicle speed sensor

• a faulty brake switch

• a faulty wheel speed sensor

• a failed brake booster

A vehicle has a low brake pedal and inefficienct braking. What could be the cause?

• Warped rotor

• Seized brake caliper slides

• a faulty master cylinder

• seized caliper piston

the best place to located the handling of hazardous chemicals is the:

• MSDS sheet

• safety handbook

• product label

• staff handbook