Automotive Practice 3

Automotive Practice 3

9th - 12th Grade

22 Qs

quiz-placeholder

Similar activities

deskriptive text Brake

deskriptive text Brake

11th Grade

20 Qs

Unit 13: You Better Work! (labor, oper, techni)

Unit 13: You Better Work! (labor, oper, techni)

8th - 12th Grade

22 Qs

Car parts - Interior

Car parts - Interior

8th - 12th Grade

21 Qs

Subject & verb agreement (Present Simple Tense)

Subject & verb agreement (Present Simple Tense)

1st - 10th Grade

20 Qs

Auto Shop Safety

Auto Shop Safety

9th - 12th Grade

25 Qs

SOAL REMIDIAL B. INGGRIS

SOAL REMIDIAL B. INGGRIS

11th Grade

20 Qs

Phrasal verbs FCE

Phrasal verbs FCE

8th - 12th Grade

20 Qs

greeting

greeting

12th Grade

20 Qs

Automotive Practice 3

Automotive Practice 3

Assessment

Quiz

English

9th - 12th Grade

Hard

Created by

Amber Coots

Used 72+ times

FREE Resource

22 questions

Show all answers

1.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

A vehicle has a steady pull to the left. All of these will cause this condition EXCEPT:

The caster angle

Low tire pressure

The camber angle

Steering U-joint coupling

2.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

The rear tires on a vehicle with independent rear suspension are worn on the inside tread. Which of the following is MOST likely the cause of this condition?

The toe

Underinflated tires

The caster

None of the above

3.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

What can cause grabby brakes?

Bad master cylinder

Contamination from oil or grease

low brake fluid

Bad brake booster

4.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

A vehicle pulls to the left only while braking. Technician A says this could be a restricted left front brake line. Technician B says this could be a frozen right front caliper. Who is correct?

Technician A

Technician B

Both A and B

Neither A or B

5.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

Front brake rotors are being re-finished using the on car brake lathe. Student A says you can use an impact wrench to tighten the hub adapters. Student B says you should mic the rotors before starting to check specification. Who is right?

Student A

Student B

Both

Neither

6.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

A technician is performing an electrical system parasitic draw test which of these is an acceptable measurement?

75 mV

100 mA

25 mv

50 mA

7.

MULTIPLE CHOICE QUESTION

10 mins • 1 pt

At idle a vehicle's battery should have how many volts?

12.0

12.6

13.9

15.1

Create a free account and access millions of resources

Create resources
Host any resource
Get auto-graded reports
or continue with
Microsoft
Apple
Others
By signing up, you agree to our Terms of Service & Privacy Policy
Already have an account?