OnShape: Features and Part Design

You can mirror an entire feature by selecting just one of its faces in the graphics area and specifying a plane or face to mirror about.

• True

• False

True or False: If the part you are designing is completely symmetric, you can complete the part by designing just half of the part and using one mirror feature.

• True

• False

When creating a part, if the features are created in the wrong order, you must delete the features and recreate them in the correct order.

• True

• False

Which of the following is NOT a type of arc in Onshape?

• Tangent Arc

• 3 Point Arc

• Centerpoint Arc

• Equal Radius Arc

Reference the image shown here. Based on what you learned about design intent, is there ONLY ONE unique series of commands that can be used to create this part?

• Yes

• No

To extrude a sketch in both directions relative to the drawing plane,you must use a Blind end type.

• True

• False

The only way to create the Tab feature shown in the image is to start a sketch on the top face of the rectangular base.

• True

• False

In the image shown, what is the best way to make all of the fillets equal in size?

• Select all of the fillets and add an equal geometric constraint

• Create a dimension for each fillet, using the same value for each

• Add horizontal and vertical geometric constraints between the endpoints of the fillets

• None of the Above

Which end type is best used when you want to extrude to a specified depth?

• Blind

• Symmetric

• Up to Vertex

• Up to Face

You must have a sketch drawn prior to activating the Extrude Remove feature.

• True

• False