EXAM200-301

Refer to the exhibit. Which route type does the routing protocol Code D represent in the output?

• internal BGP route

•  /24 route of a locally configured IP

• statically assigned route

• . route learned through EIGRP

Which type of ipv6 address is publicly routable in the same way as ipv4 public addresses?

• multicast

• unique local

• link-local

• global unicast

When the active router in an HSRP group fails, what router assumes the role and forwards packets?

• forwarding

•  listening

• standby

•  backup

Refer to the exhibit. Which action is expected from SW1 when the untagged frame is received on the GigabitEthernet0/1 interface?

• The frame is processed in VLAN 5.

• The frame is processed in VLAN 11

• The frame is processed in VLAN 1

• The frame is dropped

What are two reasons that cause late collisions to increment on an Ethernet interface? ( Choose two.)

• when Carrier Sense Multiple Access/Collision Detection is used

• when one side of the connection is configured for half-duplex

• when the sending device waits 15 seconds before sending the frame again

• when a collision occurs after the 32nd byte of a frame has been transmitted

• when the cable length limits are exceeded

Refer to the exhibit. What two conclusions should be made about this configuration? (Choose two )

• The designated port is FastEthernet 2/1

• This is a root bridge

• The spanning-tree mode is Rapid PVST+

• The spanning-tree mode is PVST+

• The root port is FastEthernet 2/1

Refer to the exhibit. Which two prefixes are included in this routing table entry? (Choose two.)

• 192.168.1.17

• 192.168.1.61

• 192.168.1.64

• 192.168.1.127

• 192.168.1.254

Refer to the exhibit. An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?

• 
• 
• 
• 

Which protocol does an access point use to draw power from a connected switch?

• Internet Group Management Protocol

• Cisco Discovery Protocol

• Adaptive Wireless Path Protocol

• Neighbor Discovery Protocol

Refer to the exhibit. How does router R1 handle traffic to 192.168.10.16?

•  It selects the RIP route because it has the longest prefix inclusive of the destination address

•  It selects the IS-IS route because it has the shortest prefix inclusive of the destination address

• . It selects the EIGRP route because it has the lowest administrative distance

• It selects the OSPF route because it has the lowest cost