Siemens/Metering

To enter the basic settings on the Siemens Flowmeter LCD, what is the password we should enter before we can start configuring?

• 1001

• 2000

• 1000

• 1010

P40 is one of the error codes for Siemens FM because there is no SENSORPROM® unit. What is the way to get rid of P40 error?

• Check installation

• Replace Mag 5000/6000

• Replace SENSORPROM® unit

• Install SENSORPROM® unit

When performing Siemens FM magsensor inspection, using an analog multimeter, the Electrode cable reading must be in the range of 5KΩ-500KΩ, the Sensor coil cable must be in what range?

• 50Ω-100Ω

• 8KΩ-800KΩ

• 5KΩ-500KΩ

• 80Ω-160Ω

What error code will occur for the Siemens Flowmeter when the volume / pulse overflow pulse is too small or the pulse width is too large?

• F63

• F61

• W21

• P42

Installing the meter is important that both the flow sensor and the MULTICAL® are properly programmed. What is the value of l / imp to be programmed for DN150-250?

• 10 l/imp

• 50 l/imp

• 2.5 l/imp

• 100 l/imp

What software is used to read logging data from the Kamstrup MULTICAL ® 62/602 calculator and top modules (e.g. hourly, daily, monthly, yearly data) as well as interval logs?

• READy Manager

• METERTOOL HCW

• LogView HCW

• USB Meter Reader

For Kamstrup MULTICAL® 62/602, if 'info' = 16384 , what is the possible reason of that error?

• signal too weak

• flow sensor mounted in wrong direction

• power supply missing

• supply voltage has been interrupted

How calculator Kamstrup MULTICAL® 62/602 can be mounted?

• Separate/Wall mounted

• Panel Mounting

• Compact mounting

• All of above

Temperature sensor T1 & T2 outside measuring range. What ''Info code" will be displayed on the Kamstrup Multical® 602?

• 8

• 12

• 16

• 4

The above mentioned battery lifetimes apply to standard installation. The battery lifetime is reduced by :

• warm ambient temperature

• frequent data connection

• connection of data modules

• All of above