Permanent Waving - Wrapping

The first part of any perm, wrapping the hair on perm rods, causes a/an:

• disulfide bond change

• chemical change

• end bond change

• physical change

The second part of any perm, the application of waving solution and neutralizer, causes a:

• physical change

• chemical change

• hydrogen bond change

• peptide bond change

The major difference between a wet set and a perm is the:

• size of the wrapping tools

• type of end bonds broken

• type of wrapping tool

• type of side bonds broken

The size of the perm tool determines the:

• base control

• placement of the curl

• size of the curl

• base direction

Wrapping the hair on small tools increases the:

• tension

• curl size

• side bonds broken

• hydrogen bonds broken

For perm wrapping, the hair is divided into panels, then into:

• partings

• base controls

• subpanels

• base sections

The position of the tool in relation to its base section is called the:

• base control

• base direction

• tool angle

• wrapping techniques

Base control is determined by the angle:

• in which the hair is combed

• of the hair to the length of the tool

• at which the tool is positioned on the head

• at which the hair is wrapped

The hair is wrapped at an angle 45 degrees beyond perpendicular to its base section in:

• half-off-base placement

• on-base placement

• cross-base placement

• off-base placement

In off-base placement, the hair is wrapped ____ to its base section.

• 45 degrees above perpendicular

• parallel

• 45 degrees below perpendicular

• perpendicular (90 degrees)