Tools And Materials in AC/DC Assembly

Long Nose is used for holding, bending, and stretching the lead of electronic component or connecting wires.

• TRUE

• FALSE

ESD waist strap is a pair of opposing blades much like scissors or wire cutters. The addition of a center notch makes it easier to cut the insulation without cutting the wire.

• TRUE

• FALSE

Soldering Tool Stand – is a place where the soldering iron is placed during usage. This will keep the soldering iron away from flammable materials.

• TRUE

• FALSE

Desoldering tool is used in removing soldered wires and components on printed circuit boards for troubleshooting and repair purposes.

• TRUE

• FALSE

Volt-Ohm-Milliammeter is an equipment that combines three functions: as a voltmeter that measures both ac and dc voltages; an ohmmeter that measures resistance; and milliammeter that measures small amount of dc current.

• TRUE

• FALSE

Phillips Screwdriver is used to drive or fasten negative slotted screws.

• TRUE

• FALSE

Mini Drill is used to bore or drill holes in Printed Circuit Board.

• TRUE

• FALSE

Apron is a protective or decorative garment worn over the front of one’s clothes and tied at the back.

• TRUE

• FALSE

Utility knife is a common tool used in cutting various trades and crafts for a variety of purposes.

• TRUE

• FALSE

Slotted screwdriver is used to drive or fasten positive slotted screws. It is a screwdriver that could take greater torque and could provide tighter fastenings.

• TRUE

• FALSE