LifePak15

Front

How do you cancel a charge on the LifePak 15?

Back

Hit the speed dial or wait 60 seconds for the charge to time out.

Front

How do you turn off the metronome on the LifePak 15? Options: Hit the shock button twice., Hold down the sync button., Press the CPR button, then use the wheel to select stop metronome., Restart the monitor.

Back

Press the CPR button, then use the wheel to select stop metronome.

Front

What should you do if no EKG waveforms are visible on the LifePak 15? Options: Increase gain on the monitor., Press the shock button., Replace the battery., Select leads and ensure in PADS mode

Back

Select leads and ensure in PADS mode

Front

When cardioverting, when should you release the shock button?

Back

Hold the shock button until you see the energy delivered screen.

Front

What must you do before each cardioversion on the LifePak 15?

Back

Re-enable sync.

Front

What causes a 'connect electrodes' warning even if patches are on? Options: Battery is low., Defibrillator pads are expired., Excess hair on the chest; shave or wax to ensure proper contact., Patient is diaphoretic.

Back

Excess hair on the chest; shave or wax to ensure proper contact.

Front

What should you do if you see a 'check cable' warning?

Back

Ensure the cable is plugged in properly; if issues persist, switch to another monitor.

Front

What is the default energy setting on the LifePak 15?

Back

200 joules. The monitor is biphasic and allows increases up to 360 J if needed.

Front

What should you check if the shock button is pressed but no shock is delivered? Options: Battery is not fully charged., Confirm that sync is disengaged by pressing the sync button again., Pads are placed in reverse., The monitor is turned off.

Back

Confirm that sync is disengaged by pressing the sync button again.

Front

Why is lead II generally used for pacing?

Back

Because QRS complexes are usually tallest in lead II, improving R wave sensing.