LIft jack and stands

Front

Which of the following is a type of lifting mechanism used in the automotive industry?
Options: a. All of the answers listed, b. Hydraulic jack, c. Mechanical jack, d. Pneumatic jack

Back

All of the answers listed

Front

When mounting an engine on an engine stand, the mounting bolts should be of the correct strength and should thread into the hole at least:

Back

six to eight turns.

Front

Which of the following is an opportunity to cause damage to a vehicle?
Options: a. All of the above, b. Allowing an inexperienced driver to operate the vehicle, Moving vehicles in and out of the shop, Working on a vehicle without covering the fenders

Back

All of the above

Front

The two-post hoist comes in all of the following configurations, EXCEPT: asymmetrical, symmetrical, semisymmetrical, bisymmetrical.

Back

bisymmetrical.

Front

All of the following are used to protect a vehicle from damage, EXCEPT: floor mats, seat covers, fender covers, used shop rags.

Back

used shop rags.

Front

Where should you keep the keys for vehicles that are being repaired in the automotive shop and not currently being used?

Back

Secure and away from the vehicle

Front

Technician A says most four-post hoists have automatic locking mechanisms. Technician B says some four-post hoists have manual safety mechanisms. Who is correct?

Back

Technician B

Front

The ___________ is useful for raising the vehicle to a height that removes the need for the technician to bend down.

Back

vehicle hoist

Front

Which of the following is NOT a corrosive? Wheel bearing grease, Baking soda, Battery acid, None of the answers listed

Back

Wheel bearing grease

Front

Technician A says vehicle inspection pits allow access to the vehicle’s underside without using a hoist or jack. Technician B says that vehicle inspection pits only need to be covered when a vehicle is over the top of them. Who is correct?

Back

Technician A