MLR Section B

Front

Which step is NOT usually done when disarming an airbag system? Options: Removing the airbag modules from the vehicle, Removing the airbag fuse, Disconnecting the electrical connector to the airbag, Disconnecting the battery

Back

Removing the airbag modules from the vehicle

Front

Where can the type of power steering fluid be found? Options: On the reservoir fill cap, In the owner’s manual, In service information, Any of the above

Back

Any of the above

Front

Accessory drive belts are checked for all except.

Back

Length

Front

Which is the preferred method to bleed air from a power steering system? Options: Raise the front wheel off the ground and turn the steering wheel lock to lock, Start the engine and allow to idle, Use a vacuum pump attached to the reservoir cap, Use a bleeding tool

Back

Raise the front wheel off the ground and turn the steering wheel lock to lock

Front

When replacing steering or suspension parts, which precaution is needed to be performed? Options: Fasteners tighten to factory specifications, Most parts need to be replaced in pair (left and right side), The front wheels should be in the straight ahead position when the final parts are tighten, All of the above

Back

All of the above

Front

A steering dampener looks like a____

Back

Shock absorber

Front

Wear indicator ball joints indicate that they are worn enough to need replacement in what location?

Back

A raised area around the grease fitting.

Front

A coil spring is correctly installed in a SLA-type of suspension system if_____

Back

One hole is covered and the other hole is open or just partially open

Front

Which statement is true about springs? Torsion bars are often adjustable to control ride height, Leaf springs use a center bolt, Spring can sag resulting in lower ride height, All of the above

Back

All of the above

Front

When performing an alignment, a scan tool is likely to be needed to perform which operation?

Back

Calibrate steering angle sensor