NIMS 20-43

Front

Which government agency regulates safety and health requirements for the industry?

Back

Occupational Safety and Health Administration

Front

A process calls for a slip or sliding fit for a 1.000” dia. shaft to fit into a hole. The clearance between the shaft and the hole should be _______________.

Back

.0009

Front

Which of the following is a possible remedy to remove material (solids) lodged in the eye?
Pull the top lid over the bottom lashes,
Rub the eye from left to right,
Pull at the corner of the eye,
To seek assistance to remove the material

Back

Pull the top lid over the bottom lashes

Front

Long thin parts have been ground and the flatness is out of tolerance. A possible cause is:

Back

Machine foundation is inadequate.

Front

If a process calls for tapping ½” – 13 NC hole using a 27/64 drill size, what percentage of thread will be obtained?

Back

75% thread

Front

While drilling a thorough hole in a drilling operation, when is the drill most likely to grab in the workpiece? Options: As it enters the workpiece., If coolant or oil is not used during the process., If you run the drill backward., As it breaks through the bottom of the workpiece.

Back

As it breaks through the bottom of the workpiece.

Front

A dial bore gage is used to inspect _______________.

Back

Holes

Front

The most important reason for the disposal of rags and wipes after use is _________________.

Back

The fire hazard potential

Front

What does the acronym TLV stand for as found on material safety data sheets?

Back

Threshold limit value

Front

What does the acronym MSDS stand for in a typical manufacturing environment?

Back

Material safety data sheet