Woodworking 1 Sec. 4 B

Front

Which should be done before installing a dado blade on the table saw? A. Disconnect the power. B. Measure the floor. C. Sand the wood. D. Stain the wood.

Back

Disconnect the power.

Front

The power miter saw is best used to cut:

Back

angles.

Front

The angle from the fence to the table of a jointer is usually set at:

Back

90°.

Front

To increase the cut of a jointer, one would: A. lower the cutter head. B. lower the infeed table. C. raise the cutter head. D. raise the outfeed table.

Back

lower the infeed table.

Front

When drilling at an angle using a drill press, one must: A. change the speed. B. lower the bit. C. raise the table. D. tilt the table.

Back

tilt the table.

Front

Snipe, caused by the planer at the beginning or end of the board, is most likely caused by an improperly adjusted:

Back

table roller.

Front

The four basic components of a spindle shaper are the spindle, table, motor, and:

Back

fence.

Front

Turning refers to producing round parts using a:

Back

wood lathe.

Front

How are most abrasives held in place on the disk sander?

Back

adhesives

Front

When shaping, material is always fed: A. against the cutter rotation, B. left to right, C. right to left, D. with cutter rotation.

Back

against the cutter rotation.