Episode 12: Check Your Sliced Model in Preview

Drag the prerequisite steps to be allowed to Preview a sliced model in the proper order.
1) ​ ​ (a)  
2)​ ​ (b)  

3) ​ ​ (c)  

4) ​ (d)  

• Create new project
• Add model to built plate
• Adjust slicing settings-printer filament type etc
• Green "Slice Plate" button

Click the picture attached to this question to enlarge.

What is the total weight of filament used for this model?

(a)  

According to the preview data, the red lines are ​ (a)  

• sparse infill
• Inner wall
• Outer wall
• Internal solid infill

What color will supports be colored in a slicer preview?

• Green
• Blue
• Gray
• Red

Match the correct line color to its type. Click the image to enlarge.

Groups:

(a) Sparse Infill

,

(b) Outer Wall

,

(c) Inner Wall

,

(d) Supports

• red

• green

• yellow

• orange

What is the most common automatic inspection message that appears?

• overhang inspection

• model too large inspect

• model too colorful inspection

• models got too much rizz inspection

What two suggestions are offered by the automatic inspection message to remedy an overhang?

• Apply supports to the model

• Reorientate the model

• Scale the model

• Adjust layer height