Cartridge Installation Procedures

This video tutorial guides viewers through the process of installing a new color cartridge in a Kodak printer. It begins with an introduction, followed by preparation steps such as shaking the cartridge. The tutorial then demonstrates how to open the printer access door, remove the orange tab, and insert the cartridge until it clicks into place. Finally, it concludes with closing the printer lid, indicating the successful installation of the cartridge.

What is the first step in preparing the cartridge for installation?

• Pressing it down

• Removing the orange bit

• Shaking it

• Cutting it open

Why is it recommended to shake the cartridge before installation?

• To make it fit better

• To mix the ink for better results

• To check for any damages

• To remove any dust

What should you do after lifting the printer access door?

• Insert the cartridge immediately

• Snap off the orange bit from the cartridge

• Close the door

• Turn off the printer

How do you open the printer access door?

• Press a button on the side

• Pull it towards you

• Push up underneath

• Slide it to the left

What indicates that the cartridge is properly installed?

• The cartridge clicks into place

• The printer beeps

• The printer light turns green

• The cartridge changes color

What is the final step after installing the new cartridge?

• Turn on the printer

• Shut the lid

• Remove the old cartridge

• Print a test page