AutoCAD

You just typed the LINE command and clicked the first point. AutoCAD is now waiting for your next action. Where should you look to know exactly what it’s asking you to do?

• The Status Bar

• The Command Line

• The Properties Palette

You want to draw a line exactly 200 mm to the right from your last point without measuring manually.
What should you type?

• @200,0

• #200,0

The RECTANGLE command shortcut is

• REC

• R

• RE

You want to make sure your lines are always horizontal or vertical. Which setting should be on?

• Object Snap

• Polar Tracking

• Ortho Mode

You need to draw lines at both 90° and 45° angles without changing modes repeatedly. Which setting will help you do this?

• Ortho Mode

• Grid Snap

• Polar Tracking

You want to draw a circle based on its center point and radius. Which method should you choose?

• Center, Radius

• 2-Point Circle

• Tangent, Tangent, Radius

You want to create a kitchen counter exactly 600 mm × 1200 mm in one go. Which command is best?

• Rectangle

• Polyline

• Line

You have two crossing lines and you only want to remove the extra part of one line. Which tool should you use?

• Erase

• Trim

• Explode

You have two parallel lines and want one of them to reach a third line. Which command will you use?

• Extend

• Offset

• Fillet

You need to rotate an object by 45 degrees around a specific point. Which command should you use?

• Align

• Rotate

• Move