Block 6 Quiz Year 1 Gateway Assessment

When performing an oil change, you notice metal flakes in the drained oil. Your FIRST action should be:

• Complete service as planned

• Flush system with cleaner

• Notify supervisor/document finding

• Ignore if no warning lights

During brake inspection, inner pads show 50% more wear than outer pads. This indicates:

• Normal wear

• Sticking caliper slide pins

• Warped rotor

• Aggressive driving

A vehicle's ABS warning light stays on. Your diagnostic process should START with:

• Check wheel sensors

• Scan for fault codes

• Inspect wiring harnesses

• Replace ABS module

When replacing a battery, you should ALWAYS:

• Disconnect negative first

• Reconnect positive first

• Reset vehicle systems

• Wear eye protection

A coolant pressure test shows 10% drop in 5 minutes. This indicates:

• Normal result

• Head gasket leak

• Radiator cap failure

• Thermostat issue

After lifting a vehicle, you notice hydraulic fluid under lift. Immediate action: (H&S)

• Continue working

• Tag-out lift/notify supervisor

• Wipe up fluid

• Ignore if small puddle

DOT 4 brake fluid boiling point BELOW ___ requires replacement: (Brake/Tyre)

• 155°C

• 180°C

• 200°C

• 230°C

AGM battery resting voltage below ___ indicates charging needed: (Electrical)

• 12.0V

• 12.4V

• 12.7V

• 13.0V

Service records missing VIN violate: (Servicing)

• Company policy

• Data Protection Act

• MOT requirements

• EU 2018/858

TBN below ___ in oil analysis requires change: (Engine)

• 1 mg KOH/g

• 2 mg KOH/g

• 5 mg KOH/g

• 10 mg KOH/g