Jaringan dan Routing

The device used to connect networks installed in homes, offices, internet cafes, or other institutions to connect to the internet. This hardware generally has the ability to block broadcast storms that can slow down network performance. The description refers to hardware ...

• NIC

• Router

• Switch

• LAN card

• LAN tester

The network used to send back IPv4 packets. In Windows, this column contains the IPv4 address assigned as an interface, referred to as...

• Static

• Metric

• Next-hop

• Interface

• Destination

The type of routing that can change according to desired conditions with certain parameters according to its protocol is the definition of...

• routing mask

• routing static

• routing dynamic

• routing tables

• routing protocol

More resistant to various hacker attempts to spoof dynamic routing protocol packets with the aim of configuring routers to hijack traffic, is one of the advantages of ....

• Router mask

• Router tables

• Router static

• Router dynamic

• Router protocol

Static routers are routers that can perform routing processes for a network, in the process done manually. The routing process is also called ....

• Separation

• Deployment

• Routing

• Limitation

• Binding

What is the difference between static routers and dynamic routers?

• Static routers determine routes while dynamic routers determine IP addresses

• Static routers are more difficult in subnetting compared to dynamic routers

• Static routers allocate IP addresses more easily than dynamic routers

• If on static routers reset the router to default mode, then dynamic routers to factory mode

• Static router configuration is done manually, while dynamic routers automatically.

A device that can function as a connector between two networks in distant places and to accommodate network load is ....

• Hub

• Bridge

• Router

• Modem

• Flashdisk

Usually, routers will recommend which path to use to pass packets based on information obtained from ....

• Static

• Metric

• Bridging

• Dynamic

• Routing table

In Cisco router configuration, to activate the interface, the command used is ....

• shutdown

• ping

• enable

• ip route

• no shutdown

Routing is a process in a network that aims to ....

• Store data on the server

• Transmit data to all network devices

• Determine the best path for data to its destination

• Secure internet connections

• Analyze data transfer speed