Flue Inspection and Gas Safety Quiz

Which of the following should be checked to ensure the terminal of a pre-cast flue is compliant?

• That it is painted

• That it complies with relevant standards

• That it is made of metal

• That it is underground

What is the purpose of looking up the flue from the catchment space during inspection?

• To check for clear unobstructed blocks

• To measure the temperature

• To install a new appliance

• To paint the inside of the flue

According to the Gas Safety (Installation and Use) Regulations, what must a person do immediately after working on a gas appliance?

• Leave the premises

• Examine the effectiveness of any flue

• Turn off the electricity

• Call the fire department

Which of the following is NOT a step in flue flow testing?

• Check permanent ventilation is adequate

• Apply a smoke match to the opening of the flue

• Paint the flue pipe

• Position and light a smoke pellet at the base of the flue/chimney

Why is it important to check that the flue pipe is a suitable distance away from joists in the loft space?

• To ensure proper insulation

• To prevent corrosion

• To avoid fire hazards and ensure safety

• To increase the length of the flue

If a flue joint is found to be unsound during inspection, what should be the next step?

• Ignore it and continue

• Seal the joint with appropriate material

• Paint over the joint

• Remove the entire flue

What is the main reason for checking the compatibility of a gas appliance with a pre-cast flue?

• To ensure the appliance fits aesthetically

• To ensure safe and efficient operation

• To reduce installation time

• To increase the cost of installation

What is the first step in the spillage test procedure for an appliance?

• Turn on the appliance to its full setting

• Apply a lighted smoke match below the draught diverter

• Close all doors and windows of the room or compartment containing the appliance

• Leave the appliance on for 10 minutes

How long should the appliance be allowed to warm up before applying the smoke match during spillage testing?

• 2 minutes

• 5 minutes

• 10 minutes

• 15 minutes

What should be done if the spillage test fails at the first attempt?

• Disconnect the appliance immediately

• Leave the appliance on for a further 10 minutes and then repeat the test

• Open all doors and windows

• Ignore the result and proceed