3.1 - Features and Part Design

Which of the following is NOT a type of arc in Onshape?

• Equal Radius Arc

• 3 Point Arc

• Tangent Arc

• Centerpoint Arc

Which type of Arc requires another entity to specify its start point?

• Tangent Arc

• 3 Point Arc

• Centerpoint Arc

• Equal Radius Arc

Using the _________ option, you can change the state of a model back to where a particular feature or features weren’t yet created.

• Undo

• Redo

• Rollback

• Save As

To extrude a sketch in both directions relative to the drawing plane, you must use which end type?

• Blind

• Through All

• Mid Plane

• Symmetric

Which end type of an Extrude feature is used to add an equal amount of material to both sides of the sketch plane?

• Symmetric

• Up To Face

• Blind

• Through All

The only way to create the Tab feature shown in the image is to start a sketch on the top face of the rectangular base.

• True

• False

Which of the following ways allow you to place one sketch line, rather than a chain of lines?

• Double click when placing the line

• Press the spacebar

• Use the right mouse button

• All of these are correct

Which of the following is an indicator that a sketch profile is closed?

• The profile will be shaded in gray

• The sketch entities will turn red

• A notification will pop up saying the profile is closed

• A green check will appear near the sketch profile

What is the best way to make all of the fillets equal in size?

• Manually adjust each fillet

• Use the equal constraint on all fillets

• Measure each fillet with a ruler

• Guess the size of each fillet

What is the correct method to ensure all fillets have the same size in a geometric design?

• Select all of the fillets and add an equal geometric constraint

• Create a dimension for each fillet, using the same value for each

• Add horizontal and vertical geometric constraints between the endpoints of the fillets

• None of these are correct