8202-525 March 2018

Who is responsible for investigating accidents on site?

• Employer.

• Health and Safety Executive.

• Health and Safety commission.

• Local authority.

How can segregation of a working area from the general public be achieved?

• Barriers and signs.

• Toe boards.

• Wearing PPE.

• Kick boards and handrails.

Who is responsible for providing adequate PPE on site?

• Employer.

• Site foreman.

• Main contractor.

• Client.

When would wooden access equipment be permitted for use?

• When they are over 5 m long.

• When they have not been painted.

• When they have not been exposed to the rain.

• When they have been erected to 45 degree angle.

What is required from employers’ to comply with RIDDOR?

• To keep a daily accident log.

• To report every incident in the workplace.

• To report incidents of injuries below seven days absence.

• To report incidents of injuries above seven days absence.

What action must be taken when flux comes into contact with the skin?

• Apply barrier cream.

• Wipe off with a cloth.

• Rinse with clean water.

• Clean skin with spirit based solvents.

What document states the correct installation and operation of a new plumbing component?

• Manufacturer’s brochure.

• Merchants catalogue.

• Manufacturer’s instructions.

• Manufacturer’s warranty.

Under safe isolation, what additional controls are in place once the breaker has been locked off correctly?

• Warning tag to identify that the circuit is currently being worked on.

• Customer should be informed on how to reinstate the supply.

• Live supplies notice should be displayed at the point of work.

• Lock off key attached to the point of isolation clearly identifying how to reinstate supplies.

How should the cistern be installed?

• On a fully supported uninsulated base to prevent condensation.

• Without base support to allow access for service.

• Directly on joists and fully insulated to prevent condensation.

• Completely insulated to prevent warming.

What size over current protection device will be needed to protect a circuit that has a 4 kW electric water heater installed on a 230 volt supply?

• 5 amps.

• 10 amps.

• 13 amp.

• 16 amps.