SRWE - Chapter 15 Static Routing

What is a static route?

• A route automatically configured by the network

• A route manually configured by a network administrator

• A route that changes dynamically based on network conditions

• A route used only for IPv6 networks

Which command is used to display the static routes in the IPv4 routing table?

• `show ip route`

• `show ip route static`

• `show ipv6 route static`

• `show ip interface brief`

What is a default static route often configured as for IPv4?

• `255.255.255.255`

• `0.0.0.0/0`

• `::/0`

• `192.168.1.1`

What is a floating static route?

• A route with the lowest administrative distance

• A backup route with a higher administrative distance

• A route that summarizes multiple networks

• A route that points to a directly connected network

Which command is used to configure a default IPv6 static route?

• `ipv6 route ::/0 {ipv6-address | exit-intf}`

• `ip route 0.0.0.0 0.0.0.0 {ip-address | exit-intf}`

• `ipv6 route 0.0.0.0/0 {ipv6-address | exit-intf}`

• `ip route ::/0 {ip-address | exit-intf}`

What is a summary static route used for?

• To increase the number of routes in the routing table

• To represent multiple network addresses under a single route

• To specify a single IP address as the destination

• To automatically configure routes

What does a fully specified static route include?

• Only the next-hop IP address

• Only the exit interface

• Both the next-hop IP address and the exit interface

• Only the destination network

What is a host route?

• A route that specifies a single IP address as the destination

• A route that covers all possible IP addresses

• A route that is automatically created for each interface

• A route that summarizes multiple networks

Which command is used to configure a static IPv4 route?

• `ip route network-address subnet-mask { ip-address | exit-intf [ip-address]} [distance]`

• `ipv6 route ipv6-prefix/prefix-length {ipv6-address | exit-intf [ipv6-address]} [distance]`

• `show ip route static`

• `show ipv6 route static`

What is a directly connected static route?

• A route that points to a network directly connected to the router

• A route that is used as a backup

• A route that specifies a single IP address as the destination

• A route that is automatically created for each interface