IB Physics

At 60 seconds, how far had this object traveled? 

• 0 m
• 10 m
• 20 m
• 40 m

An airplane lands on a runway with a velocity of 150 m/s. How far will it travel until it stops if its rate of deceleration is constant at -3 m/s²?

• 525 m
• 3750 m
• 6235 m
• 9813 m

Tags

NGSS.HS-PS2-1

A ball is thrown downward from the top of a roof with a speed of 25 m/s. After 2 s, its velocity will be:

• 19.6 m/s
• -5.4 m/s
• -44.6 m/s
• 44.6 m/s

Tags

NGSS.HS-PS2-1

How much time would it take for an object to fall 4.7 meters?

• 0.959 s
• 4.79 s
• 0.979 s

A ball rolls off a table top and strikes the floor as shown. Given the measurements made, the time the projectile spent in the air is ---.

• 17 s

• 0.34 s

• 0.58 s

• 0.49 s

Tags

NGSS.HS-PS2-4

A ball rolls off a table and strikes the floor, as shown. If the time the ball spent in the air was 0.58 s, how fast did the ball leave the table?

• 3.6 m/s

• 1.2 m/s

• 2.9 m/s

• 0.99 m/s

Tags

NGSS.HS-PS2-1

A projectile is launched, and its vertical and horizontal velocities are shown in the graph. What is the magnitude of the projectile's initial velocity?

• 25 m/s

• 10 m/s

• 325 m/s

• 18 m/s

Tags

NGSS.HS-PS2-1

Two balls of the same mass begin at a height of 2m. One is released from rest while the other begins with a horizontal velocity of 5m/s. Which object its the ground first?

• Ball A
• Ball B
• Both balls his the ground at the same time
• unable to determine with information given

Tags

NGSS.HS-PS2-4

A wooden block rests on a rough board. The end of the board is then raised until the block slides down the plane of the board at constant velocity v. 
Which row describes the forces acting on the block when sliding with constant velocity? 

• A
• B
• C
• D

Tags

NGSS.HS-PS2-1

A block rests on a rough horizontal plane and a force P is applied to the block as shown. 
The normal reaction between the plane and the block is N and the frictional force between the block and the plane is F. The coefficient of static friction between the block and the plane is μS and initially P is zero.
As P is increased in value, which one of the following statements is true concerning the relationship between F, N and μS ? 

• F is always equal to μ_SN
  
• F is always greater than μ_SN 
• F is always less than μ_SN
  
• F can be equal to μ_SN 

Tags

NGSS.HS-PS2-1