FC #1

What are the primary features of the RRC3?

• User-selectable beep frequency

• 3 Output capable Drogue, Main, and Auxiliary outputs

• Configurable Deployment operations

• Configurable third 'Aux' output

• Configurable Main and Arming altitudes

What is the minimum altitude for arming the RRC3?

• 50 feet

• 100 feet

• 200 feet

• 300 feet

What types of batteries can be used with the RRC3?

• Alkaline

• NiCd

• NiMH

• LiPo

• LiON

What is recommended for the battery and power switch terminals?

• 20-22 AWG wire

• 18-20 AWG wire

• 22-24 AWG wire

What should you do if you use the 'twist and tape' method?

• Do not poke the wires back into the airframe

• Poke the wires back into the airframe

• Leave the wires exposed

What is the nominal resistance for low current devices?

• 1 to 2 ohms

• 2 to 3 ohms

• 0.5 to 1 ohm

What should you do before arming the altimeter?

• Have bystanders move to a safe distance

• Install the motor igniter

• Connect the battery

What does a long beep indicate during launch detect mode?

• No continuity on any event terminal

• Continuity on the main terminal

• Continuity on the drogue terminal

What should you do if you need to remove the rocket from the pad?

• Disconnect and remove the igniter

• Leave the igniter connected

• Turn off the altimeter immediately

What is the purpose of the RRC3's Open Drain MosFET device?

• To activate the ejection charges

• To power the altimeter

• To measure altitude