Quiz on Section 701

What is the scope of Section 701?

• It applies to emergency showers in industrial areas.

• It applies to electrical installations in locations containing a fixed bath or shower.

• It applies to all types of water installations.

• It applies only to outdoor showers.

What is Zone 0 in the context of Section 701?

• The area outside the bathroom.

• The interior of the bathtub or shower basin.

• The ceiling above the shower.

• The floor outside the shower.

How is Zone 1 defined in Section 701?

• It includes the entire bathroom.

• It is limited by the finished floor level and a horizontal plane 2.25 m above it.

• It is the area outside the bathroom door.

• It includes only the ceiling.

What is the height of Zone 0 for showers without a basin?

• 0.20 m

• 0.15 m

• 0.10 m

• 0.05 m

What happens to the space under the bathtub or shower basin in Zone 1?

• It is considered part of Zone 0.

• It is considered outside the zones if only accessible with a tool.

• It is always part of Zone 2.

• It is not considered in any zone.

What is not allowed to be used as a protective measure according to Regulation 701.410.3.5?

• Obstacles and placing out of reach

• Electrical separation

• SELV or PELV

• RCDs

What is the purpose of additional protection by RCDs as mentioned in Regulation 701.411.3.3?

• To provide basic insulation

• To serve low voltage circuits

• To supply electric floor heating systems

• To connect metallic waste pipes

According to Regulation 701.413, electrical separation should only be used for which of the following?

• Multiple socket-outlets

• Circuits supplying one item of current-using equipment

• All circuits in a building

• Metallic central heating pipes

What is required for SELV and PELV circuits in zones 0, 1, and 2 according to Regulation 701.414.4.5?

• Basic insulation or barriers/enclosures

• RCD protection

• Earth-free local equipotential bonding

• Electrical separation

What does Regulation 701.415.2 specify about supplementary protective equipotential bonding?

• It should be omitted in all cases

• It should connect metallic waste pipes only

• It should connect all extraneous-conductive-parts

• It should be installed outside the building only