General RMC

Which of below statements are true about PVF used in TDR? 

• It is a measure of how cable construction affects the speed with which a TDR pulse travels down a cable.

• PVF is propagation velocity per foot.

• PVF is propagation velocity factor.

• If PVF is unknown, TDR cannot be used at all

• It is ratio of speed of pulse in cable to speed of light in air.

When you need to find engineering data for a tool, which of the following website(s) will possibly have the information?

• SWPS

• iLearn

• OneCAT

• ComCAT

• InTouch

What distinguishes special clamps from regular?

• Shape

• Cost

• Size

• Cost

Why does the Olive Gland need to be bored-through? 

• To allow communication between gauge and tubing 

• To enhance metal to metal seal

• To increase corrosion resistance

Which electrical check should not be performed after the gauge is connected to the PDC cable?

• Reverse Resistance

• Diod

• Capactiance

• Forward Resistance

• Insulation check

What is the size of the green wire in the connector of a downhole gauge?

• 18 AWG

• 22 AWG

• 20 AWG

Which of the following checks can be used to confirm the length of the PDC cable?

• Resistance

• Capacitance

• Stamp on encapsulation

• TDR

• Drum measurements

Which downhole monitoring measurements are taken by the XPQG gauge?

• pressure

• temperature

• velocity

• porosity and permeability

Which of the following are types of reservoir monitoring measurements ?

• Single-point measurements

• Acoustic wave measurements

• Distributed temperature measurements

• Pressure mapping

What are the RMC electrical test equipment and devices do you know?

• TDR (Time Domain Reflectometer)

• Signal analyzer

• Multimeter

• Megger

• Thermal imaging sensor