What is a requirement for an internal water meter for safety?

• It needs to be cross bonded.

• It needs to be placed outside.

• It needs to be painted yellow.

• It needs to be installed by a plumber.

What is shown in the image labeled "A boundary meter box"?

• A boundary meter box

• An internal water meter

• A stop valve

• A drain off valve

What color is the MDPE pipe used to identify wholesome water?

• Red

• Blue

• Green

• Yellow

What is the minimum size for a modern property pipe?

• 20mm

• 25mm

• 30mm

• 35mm

What type of copper can be used according to the requirements?

• Hard copper

• Soft copper (R220)

• Medium copper

• Flexible copper

Where is the meter commonly installed at the property boundary?

• In a chamber

• Inside the house

• On the roof

• In the basement

Where can water be isolated according to the requirements?

• Only in the road

• Only at the meter

• Only at the point of entry to the property

• In the road, at the meter, or at the point of entry to the property

Under which regulations is everything from the external stop valve at the meter regulated?

• Water Regulations 1995

• Water Regulations 1997

• Water Regulations 1999

• Water Regulations 2001

According to the Water Regulations, where should a stop valve be located?

• Outside the building

• Inside the building, above floor level, near the point of entry

• Below floor level

• Anywhere in the building

What is the purpose of installing a stop valve as per the Water Regulations?

• To increase water pressure

• To prevent water from going to any point in the building when closed

• To filter the water

• To reduce water temperature