Refresh Quiz

What is the primary purpose of a First Hop Redundancy Protocol?

• It reduces routing failures by allowing Layer 3 load balancing between OSPF neighbors that have the same link metric

• It reduces routing failures by allowing more than one router to represent itself as the default gateway of a network

• It allows a router to use bridge priorities to create multiple loop-free paths to a single destination

• It allows directly connected neighbors to share configuration information

Refer to the exhibit OSPF is running on this network, how does Router2 handle traffic from Site B to 10 10.13. 128/25 at Site A?

• olt sends packets out of interface Fa0/1

• It load balances traffic out of Fa0/1 and Fa0/2

• It is unreachable and discards the traffic

• It sends packets out of interface Fa012

Refer to the exhibit. Which command must be executed for G1/1 on SW1 to become a trunk port if Gi1/1 on SW2 is configured in desirable or trunk mode?

• switchport mode dott-tunnel

• switchport mode dynamic desirable

• switchport mode dynamic auto

• switchport mode trunk

A network engineer must create a diagram of a multivendor network Which command must be configured on the Cisco devices so that the topology of the network is allowed to be mapped?

• Device(config)#lldp run

• Device(config)#cdp run

• Device(config-inacdp enable

• Device(config)flow-sampler-map topology

Refer to the exhibit. After the configuration is applied, the two routers fail to establish an OSPF neighbor relationship. What is the reason for the problem?

• Router2 is using the default hello timer

• The OSPF router IDs are mismatched

• The OSPF process IDs are mismatched

• The network statement on Router1 is misconfigured

Refer to the exhibit router R1 is running three different routing protocols. Which route characteristic is used by the router to forward the packet that it receives for destination ip 172.16.32.1?

• Cost

• Administrative distance

• Metric

• Longest prefix

Refer to the exhibit. An administrator configures four switches for local authentication using passwords that are stored in a cryptographic hash. The four switches must also support SSH access for administrators to manage the network infrastructure. Which switch is configured correctly to meet these requirements?

• SW1

• SW2

• SW3

• SW4

Refer to the exhibit. Only four switch are participating in the VLAN spanning-tree process.

Branch-1 priority 614440
Branch-2 priority 39167273
Branch-3 priority 0
Branch-4 root primary

• Branch-1

• Branch-2

• Branch-3

• Branch-4

Refer to the exhibit. What are conclusions about this configuration? (Choose two)

• The spanning-tree mode is PVST+

• This is a route bridge

• The designated port is FastEthernet 2/1

• The spanning-tree mode is Rapid PVST+

• The root port is FastEthernet 2/1

Refer to the exhibit. With which metric was the route to host 172.16.0.202 learned?

• 0

• 110

• 38443

• 3184439