Pre-assessment

The purpose of lock out and tag out is to prevent injury due to the _______ startup of machines and equipment or release of stored energy.

• Normal

• Regulated

• Unexpected

• Scheduled

What does MTC stands for?

• Major Treatment Case

• Management Treatment Case

• Medical Treatment Case

• Malfunction Treatment Case

1. Select a method of Primary Isolation for piping equipment?

• Single block valve

• Tagged valve

• Disconnected lock valve

• Blinding

Why does the issuer ask the receiver for the scope of work and equipment used?

• So both can agree to the precautions on the permit

• To ensure tools and equipment are not stolen

• To make sure the receiver is certified to use the equipment

• To check his knowledge

1. We isolate equipment and use LOTO to make sure that the equipment cannot be ______.

• Taken to a shop for repairs

• Started-up, leak or cause electric shock

• Shut down on purpose

• Shut down by accident

• When do we conduct gas test?

• When management is on site

• At least daily

• Before a work permit is issued

• Every four hours

What is the purpose of the work permit system?

• To authorize all work activity in non-restricted areas

• To authorize non-hazardous work

• To document when receivers start work for time keeping

• To identify hazards and appropriate control measure

When shall you report all work-related injuries, fires, spills and near misses?

• After Two working days

• Immediately

• After five working days

• After LP consultation

What should you do if your car breaks down while driving off-road?

• 1. Follow your tracks back to the road

• 1. Send the second passenger to find help

• 1. Stay in your car and wait

• 1. Try to find the nearest road

What you should do if the H2S reading 100PPM?

• Replace the gas testing device

• Continue your work 

• Call your supervisor

• Stop work