ZTE-TM-NGT 2024

Which of the following routing protocols are used in TM NGT network?

• ISIS & BGP

• OSPF & ISIS

• EIGRP & BGP

• OSPF & BGP

Which network protocol is used for performance & fault monitoring?

• SNMP

• TCP

• SMTP

• FTP

What is the function of BFD?

• To detect link failure

• To export routing table to peers

• To protect router from high CPU utilisation

• To avoid broadcast storm

Which of the following is public IP address?

• 172.32.1.1

• 10.15.14.12

• 192.168.52.62

• none of the above

Which of the following command is correct to check routes exported to a bgp neighbor?

• hsezt41.cbj#show ip bgp neighbor out 58.26.99.208

• hsezt41.cbj#show bgp ipv4 unicast neighbor in 58.26.99.208

• hsezt41.cbj#show ip bgp ipv4 unicast neighbor out 58.26.99.208

• hsezt41.cbj#show bgp ipv4 unicast out neighbor 58.26.99.208

What is the routing protocol configured between Agg and CE router?

• BGP

• OSPF

• ISIS

• EIGRP

If a customer complain that his Internet is not working, which of the following steps is correct?

• check alarm > check interface status > ping to customer IP

• check power > check board status > check temperature

• check alarm > check bgp status > check configuration

• check routing table > check interface status > check customer firewall

How to check VoBB users connected to an interface?

• show arp

• show ip forwarding route

• show mac vpls instance

• show isis adjacency

How many layers does TCP/IP architecture have?

• 4

• 5

• 3

• 6

Refer to the exhibit. An engineer must ensure that all traffic entering AS 200 from AS 100 chooses Link 2 as an entry point. Assume that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers. Which configuration accomplishes this task?

• R3(config-route-map)#set as-path prepend 200 200 200

  R3(config)#router bgp 200

  R3(conflg-router)#neighbor 10.1.1.1 route-map PREPEND out

• R4(config-route-map)#set as-path prepend 200 200 200

  R4(config)#router bgp 200

  R4(conflg-router)#neighbor 10.2.2.2 route-map PREPEND out

• R4(config-route-map)#set as-path prepend 100 100 100

  R4(config)#router bgp 200

  R4(config-router)#neighbor 10.2.2.2 route-map PREPEND in

• R3(config-route-map)#set as-path prepend 100 100 100

  R3(config)#router bgp 200

  R3(config-router)#neighbor 10.2.2.2 route-map PREPEND in