Cisco 2, Module 15

What type of static route is created when the next-hop IP address and exit interface are specified?

• 1. fully specified static route

• 1. recursive static route

• 1. directly connected static route

• 1. floating static route

What is a characteristic of a default static route?

• 1. It identifies the gateway IP address to which the router sends all IP packets for which it does not have a learned or static route.

• 1. It uses a single network address to send multiple static routes to one destination address.

• 1. It is configured with a higher administrative distance than is the original dynamic routing protocol.

• 1. It backs up a route already discovered by a dynamic routing protocol.

What is the purpose of a floating static route?

• 1. It allows summarization of contiguous networks.

• 1. It allows connectivity to remote destinations that are not contained in the routing table.

• 1. It allows an alternate connection to be used when the preferred link fails.

• 1. It is commonly used when a dynamic routing protocol is not being used.

What command, or set of commands, would be used to determine if the following configuration on router HQ works as designed?

• 1. HQ(config)# interface serial 0/1/0
     HQ(config-if)# shutdown
     HQ(config-if)# end
     HQ# show ip route

• 1. HQ# show ip interface brief

• 1. HQ# show ip route

• 1. HQ# ping 128.107.0.99
     HQ# ping 64.100.0.5

• 1. HQ# traceroute 128.107.0.99

Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?

• 1. to act as a gateway of last resort

• 1. to load-balance the traffic

• 1. to be the priority route in the routing table

• 1. to be used as a backup route

Which type of static route typically uses the distance parameter in the ip route global configuration command?

• summary static route

• floating static route

• default static route

• standard static route

Which type of static route that is configured on a router uses only the exit interface?

• default static route

• directly connected static route

• fully specified static route

• recursive static route

A network administrator is configuring a route to forward packets to a specific web server. What type of route should be configured by the administrator?

• an OSPF route

• a default route

• an EIGRP route

• a host route

• a static route with an administrative distance higher than 1

Which command would create a valid IPv6 default route?

• ipv6 route ::/0 fe80::1

• ipv6 route ::/0 2001:db8:acad:2::a

• ipv6 route ::/128 2001:db8:acad:1::1

• ipv6 route 2001:db8:acad:1::/64 ::1

Which static route statement shows a recursive IPv6 static route?

• ipv6 route 0::/0 S0/0/0

• 1. ipv6 route 0::/0 S0/0/0 254

• 1. ipv6 route 2001:db8:cafe:1::/56 S0/0/0

• 1. ipv6 route 2001:db8:cafe:1::/56 2001:db8:1000:10::1

• 1. ipv6 route 2001:db8:cafe:1::/56 S0/0/0 2001:db8:1000:10::1