t511/t711 ST Day5 Review Quiz

What is the task of the transfer unit ？

• Holding the probes.

• Moving the probes over the whole range of reagent storage, analyzer unit, sampling unit.

• Detect the cuvette (present or not present).

• Providing level detection for all probes.

When is level detection used on the reagent probes?

• For reagent level detection.

• For initialization of the probes.

• For RVC(Reagent Volume Check).

• For teaching the modules / teach transfer unit

When is level detection used on the sample probes?

• For RVC(Reagent Volume Check)

• For level sensing of open tubes

• For level sensing in closed tubes

• For teaching the modules / teach transfer unit

On the t711 transfer units which probes have the heating function?

• R1 probe

• R2 probe

• R3 probe

• S1 probe

What statements are right about the probe with heating function?

• One sensor is for temperature control.

• One sensor is for temperature monitoring.

• the target temperature for the probe is 37^oC.

• If the temprtature difference exceed  1^oC  there will be an error.

What are the initialization steps of the transfer units?

• Calibrate Tools

• Probe bent check

• Move range check

• Probe referencing followed by rinsing of probes in washtubes.

On the t711 transfer units, which probe is used to reconstitute the lyophilized reagent?

• R1 probe

• R2 probe

• R3 probe

• S1 probe

What's the power voltage that t 711 transfer unit provide for the motor Z-axis S1?

• 5VDC

• 24VDC

• 35VDC

• 42VDC

On the t711 transfer units which PCB is responsible for the motor Z-axis S1?

• PCB YZ Module 18

• PCB MZ18 ELLD

• PCB Motion Control with MZ18 Interface

• PCB Connector

What statements are right if you replace the PCB MZ18 ELLD for R1 probe?

• You need teaching the transfer unit.

• You need teaching the reagent storage.

• You need format the PCB.

• You need set the dip switch.