Set No 3

How to make a random line with an angle of 40 degrees to the x axis

• "will write 0 <40"

• "will write 2 <40"

• "will write 3<40"

• "will write 4 <40"

When should I use the Block Editor

• To write text block

• To fix outer block

• To fix dynamic block

• To store it in another version of AutoCAD

Print scale 1:50 means that

• The draft is 50 times less expensive than

  the original

• A 3 cm corresponds to half a meter

• A measure corresponds to 50 cm

• None of the above

What is the difference of two regular 8- gonon, which is one inscribed and another circumscribed circle

• No difference

• different opening angles

• different side length

• different crowd sides

Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would

• "type @3<45 and enter"

• "type 3 back slash and enter"

• "type 3 forward slash and enter"

• "type 3 and try to use the Dynamic Input

  readout to find the end point"

A line with a tapering width can be easily created by using the tool.

• circle

• eclipse

• line

• polyline

The UCS icon represents the intersection

of the

• X axis

• Y axis

• Z axis

• All of the above

When using the direct entry method to create a horizontal line exactly three inches long the drafter should first.

• pull the line from away from the starting point very carefully

• insure that Ortho is on

• enter 3 for the length of the line

• read the coordinate position on the Dynamic Readout

In order to set drawing limits for a "C" size architectural drawing the drafter should set the limits to

• "0,0 and 2,9"

• "0,0 and 17,11"

• "0,0 and 18,24"

• "0,0 and 34,24"

One quick way to view the entire drawing area is to use the Zoom command by typing

• type Z enter A enter

• type Z enter E enter

• type SHOWALL enter

• type ALL enter