FUN 101 Week 9

Tech A says: in order to make a threaded hole for a bolt... You have to drill the hole bigger than the bolt. Tech B says: In order to make a threaded hole for a bolt... You must use a die and the die must be the same size as the bolt. Who is correct?

• Tech A

• Tech B

• Both Tech A and B

• Neither Tech A nor B

Whats the name of the tool used to loosen or tighten the drill around a bit.?

• Key

• Chuck

• Rabbit

• Beaver

• Toothed Handle

If your Tap is 3/8 of an inch.... What size drill bit should be used to make the hole?

• 3/8"

• 5/16"

• 9/32"

• 7/16"

• 11/16"

Your drill bit is .6875".... What Tap would work to make a threaded hole for a bolt?

• 5/8"

• 1/2"

• 7/8"

• 3/4"

• 9/16"

Match the following

• Doesn't need a Chuck

• 
• Die Wrench

• 
• Just Chuck

• 
• Needs a Chuck

• 
• Tap Wrench

• 

Tech A says: When using a Die... The side with the numbers should be facing outward after installing it in the Die Wrench. Tech B says: The Die should be the same size as the bolt being cut. Who is correct?

• Tech A

• Tech B

• Both Tech A and B

• Neither Tech A nor B

What is the decimal equivalent of 3/16" ?

• .1875

• .3125

• .3750

• .1250

• .0625

What is the fraction equivalent of .5625" ?

• 1/2

• 7/16

• 3/8

• 9/16

• 5/16

Match the following

• Panini Press

• 
• Bench Press

• 
• Hydraulic Press

• 
• Drill Press

• 
• Bench Vise

• 

Tech A says: when drilling in metal its best to use the drill at full speed. Tech B says: Even if the drill bit is cutting into the metal, its best to use some lubrication to prevent the bit from overheating. Who is Correct?

• Only Tech A is correct
• Only Tech B is correct
• Both Tech A and Tech B are correct
• Neither Tech A nor Tech B are correct