6.1 v1s0 fix

1. What is threaded at both ends and does not have a head?

• a. An external wrenching bolt.
• b. An internal wrenching bolt.
• c. A stud.
• d. A nut.

2. How many standards for threads are used?

• a. 1.
• b. 2.
• c. 3.
• d. 4.

3. What type of bolt is used more than any other type?

• a. Internal wrenching bolt.
• b. External wrenching bolt.
• c. Hexhead bolt.
• d. Clevis bolt.

4. What technical order contains information about hardware?

• a. TO 32-1-101.
• b. TO 1-1A-8.
• c. TO 1-1-8.
• d. TO 0-1-2.

5. What is the diameter of a bolt with the identification AN7?

• a. 7 inches.
• b. 7/16 inch.
• c. 7 centimeters.
• d. 7 millimeters.

6. What is device that is screwed on to the threaded end of a bolt, stud, or screw?

• a. Thread.
• b. Rivet.
• c. Wire.
• d. Nut.

7. Which style of nut can be screwed on or off by using fingers instead of a tool?

• a. Wing nut.

• b. Check nut.
• c. Receptacle.
• d. Clamp.

8. What washer is used to hold nuts tightly in place?

• a. A ball and socket rivet.
• b. A countersunk rivet.
• c. An aluminum rivet.
• d. A Lock washer

9. Why should the technical order for hardware on a piece of equipment always be followed?

• a. It doesn't have to be followed if another piece fits.
• b. If no technical order is available, it's all right.
• c.·Substitution can cost equipment and lives.
• d. Substitution might cost more money.

10. What measurement is used to measure the pitch of a screw?

• a. Diameter.
• b. Radius.
• c. Length.
• d. TPI.