FINISHING 1

1.    Select the correct terminology of safety

•    Emergency plan if accident occur at workplace.

•    The standard needs to follow to do job in workplace

•    Standard operating procedure during handling machine or tool

•    The control of recognized hazards in order to achieve an acceptable level of risk.

1.    Safety very important in composite manufacturing. What is the function of respirator?

•    Remove fume produce from chemical reaction

• Protect from splashes or spray of any subtances

    

• Protect from contamination, such as chemical mixing.

• Protect with hazardous substances, such as gases, solvents etc.

1.    What are the task on Check Product Finishing Operation Requirements?

                               i.         Job order information

                              ii.        Product specification

                             iii.        Equipment/tools specification and operation manual

Type of cutting tools

•    i and ii

• i,ii and iii

• ii, iii and iv

• i,ii, iii and iv

1.    The meaning of  PPE is

 

• Production Provide Equipment

• Personal Protective Equipment

• Personal Protective Environment

• Personal Performance Employee

1.    The following are the things that have job duties EXCEPT.

  

• Plan and design products and systems.

• Setup and operate machines

• Purchase the material

• Prepare financial reports.

1.    What is the objective of drilling process?

• a)    Process to trim the panel to desired size

     

• Process to smooth the surface of composite.

• Process to make a hole depend on the size required

• Process to remove burr on the edge of composite panel

1.    What is the function of ream?

• use to enlarge the hole

• use to make countersink

• use to make a center hole

• use to drill the actual hole

1.    What is the purpose of countersink process?

  

• Countersink use to prepared the hole for rivet process

• Countersink use to enlarge the hole after drilling process

• Countersink function as finishing the surface of hole after drilling process.

• Countersink use to install screw, bolt etc and can be inserted flush with the surface.

1.    What is the function of jig in drilling process?

  

• Jig use as marking the hole before drilling process.

• To obtain safety to personel during drilling process.

•   To reduce vibration on the panel during drilling process.

•    To obtain positional accuracy, locate and guide drills and reamers of the holes.

1.    List below is common measuring tool use during trimming process EXCEPT

• a)    Ruler

• b)    L-Square

• c)    Shear cutter

• d)    Tape measure