Vinyl Cut 103

What is the first step to take after the vinyl has been cut by the vinyl cutter?

• Apply transfer tape immediately

• Weed out the excess vinyl

• Remove the entire sheet from the cutting mat

• Transfer the design to the target surface

Which tools are commonly used for weeding vinyl? Select all that apply

• Scissors

• Tweezers

• A weeding hook

• A ruler

What is the purpose of weeding the vinyl?

• To remove the design

• To remove excess vinyl

• To make the design smaller

• To straighten the edges of the design

When should transfer tape be applied to the vinyl?

• Before weeding

• After removing the design from the backing paper

• After transferring the design to the target surface

• After weeding but before removing the design from the backing paper

Why did the vinyl cutter go to therapy?

• It had separation issues with the designs.

• It couldn't find its groove.

• It felt stuck in a sticky situation.

What is the purpose of using transfer tape?

• To protect the vinyl from damage

• To make weeding easier

• To hold the design together while transferring it to the target surface

• To trim the edges of the design

How should you apply pressure when using transfer tape?

• Evenly across the entire design

• Only on the edges of the design

• Only on the center of the design

• No pressure is needed

Which side of the transfer tape should be facing the vinyl design?

• Transfer tape is not necessary

• Either side will work

• The non-adhesive side

• The adhesive side

Why did the vinyl cutter become a hairstylist?

• It had a sharp sense of style.

• It was always a cut above the rest.

• It knew how to make precise cuts.

How should you apply the vinyl design with transfer tape onto the target surface?

• From one corner to the opposite corner diagonally

• From the center outward

• From one side to the other side horizontally

• In a circular motion