CU6 Quiz 4

Which of the processes not within the network troubleshooting?

• Scanning viruses

• Installing cables or Wi-Fi devices

• Updating firmware devices on router switch.

• Configuring a router, switch or any network management device.

Which of the solution is last step for Network Cable Is Unplugged?

• Replace the Ethernet network adapter

• Ethernet cable is damaged verify and replace

• Disable the Ethernet network adapter when you are not using it

• Check both the ends of the Ethernet cable are connected to the adapter

Which of the basic network problem is over utilized then the capacity and due to overload condition, the device will start behaving abnormally?

• Traffic overload

• Network IP issue

• Configuration issue

• Connectivity problem

Which of the network problem message has shown in the figure 1?

• Conflict of IP Address

• Wireless can’t connect

• Unable to Join Network Failure

• The Network Path Cannot Be Found

1.    Which of the following is the step of solution for Limited or No Connectivity?

 

I. Reset the router temporarily resolves this issue

II. replace network cable to determine whether it resolves

III. Check the wireless security configuration on the computer network adapter or update it

IV. reboot the computer, router and broadband modem together to reset the connection

• I, II, III, IV

• I, III, II, IV

• III, I, IV, II

• III, II, I, IV

Using a ____________ measure the signal strength from the affected area, and if possible, conduct a site survey in the area to look for rogue or unknown APs.

Check the client configuration to see which _______ it is setup to use. If this is the wrong server, adjust this setting in the client or in the DHCP server which provided it.

Check the network name ____ setting on the iPhone and ensure the Wi-Fi access point.

Check the security configuration ___________ on the iPhone to ensure the encryption keys or passphrases value

The ___________ error prevents your computer from joining the network.