P2_INT_Chapter 10_Test

A computer can access devices on the same network but cannot access devices on other networks. What is the probable cause of this problem?

• The cable is not connected properly to the NIC.

• The computer has an invalid IP address.

• The computer has an incorrect subnet mask.

• The computer has an invalid default gateway address.

Provide security on the console.

• Router(config)# hostname CL1

• Router(config)# enable password Cisco

• Router(config-line)# password class

• Router(config)# banner motd #

Displays a message when the router is accessed.

• Router(config)# hostname CL1

• Router(config)# enable password Cisco

• Router(config-line)# password class

• Router(config)# banner motd #

Configures a name on the router.

• Router(config)# hostname CL1

• Router(config)# enable password Cisco

• Router(config-line)# password class

• Router(config)# banner motd #

A new network administrator has been asked to enter a banner message on a Cisco device. What is the fastest way a network administrator could test whether the banner is properly configured?

• Reboot the device.

• Exit global configuration mode.

• Power cycle the device.

• Exit privileged EXEC mode and press Enter .

Unsecure remote access.

• SSH

• FTP

• Telnet

• AUX

Remote access method that uses encryption.

• SSH

• FTP

• Telnet

• AUX

Match the phases to the functions during the boot up process of a Cisco router. (Not all options are used.)

- Phase 1

• - Perform the POST and load the bootstrap program.

• - Locate tand load the startup configuration file

• Locate and load the Cisco IOS software

• Enter setup mode

Match the phases to the functions during the boot up process of a Cisco router. (Not all options are used.)

- Phase 2

• - Perform the POST and load the bootstrap program.

• - Locate tand load the startup configuration file

• Locate and load the Cisco IOS software

• Enter setup mode

Match the phases to the functions during the boot up process of a Cisco router. (Not all options are used.)

- Phase 3

• - Perform the POST and load the bootstrap program.

• - Locate tand load the startup configuration file

• Locate and load the Cisco IOS software

• Enter setup mode