Construction Hand Tools

One of the hazards associated with a table saw is the possibility of _______as the stock gets pinched as it travels through the saw blade.

When cutting trim molding around a doorframe, you would most likely be performing ______.

____________are formed when the tongue of a workpiece is fit into a rectangular cutout or opening on an adjoining piece.

A cut that is made across the sloping edge or side of a workpiece at an angle of less than 90 degrees is known as a ___________.

The _____________should be sharpened on a bench grinder to ensure smooth cutting

If a long board has an imperfect edge, a jointer plane can be used to make it________.

Use a ________to hold a door safely on edge when planing it.

The installation of a strike plate and hinges in a doorjamb would require

When measuring, account for the amount of material removed by the saw blade, which is known as the ______________.

A cut made across the grain in lumber is known as a ___________.