AUTC 204 Introduction

A set of gears that causes the speed of the output shaft to

be less than that of the input shaft is called a(n) _____

gear.

• Reduction

• Overdrive

• Direct

• Downshift

When the input and output shafts are turning at the same

speed, the transmission is in _____ drive.

• Reduction

• Direct

• Over(drive)

• Quantum

Which of the following torque converter parts is connected

directly to the engine crankshaft?

• Impelller

• Stator

• Turbine

• None of the above

Which of the following gears is not part of a planetary

gearset?

• Ring Gear

• Sliding Gear

• Sun Gear

• Planet Carrier

A band tightens around a _____.

• Rotor

• Drum

• Turbine

• Tambourine

Transmission and transaxle cases are being discussed.

Technician A says that the case holds the other transmission

parts. Technician B says that the case may contain

fluid passages. Who is right?

• (A) A only

• (B) B only

• (C) Both A and B

• (D) Neither A nor B

Technician A says that one type of transmission fluid can

be used in all transmissions and transaxles. Technician B

says that additives are available to convert common fluids

into special fluids. Who is right?

• (A) A only

• (B) B only

• (C) Both A and B

• (D) Neither A nor B