CCNA Module 1 Review Quiz

When configuring a switch for SSH access, what other command that is associated with the login local command is required to be entered on the switch?

• login block-for seconds attempts number within seconds
• password password
• enable secret password
• username username secret secret

Which statement describes the system LED operation on Cisco Catalyst switches?

• If the LED is blinking green, the system is operating normally.
• If the LED is amber, the system is not powered on.
• If the LED is blinking amber, the switch is performing POST.
• If the LED is amber, the system is receiving power but it is not functioning properly.

What type of Ethernet cable would be used to connect one switch to another switch when neither switch supports the auto-MDIX feature?

• straight-through
• coaxial
• rollover
• crossover

What advantage does SSH offer over Telnet?

• more connection lines
• encryption
• connection-oriented services
• username and password authentication

A network administrator has configured ​VLAN 99 as the management VLAN and has configured it with an IP address and subnet mask. The administrator issues the show interface vlan 99 command and notices that the line protocol is down. Which action can change the state of the line protocol to up?

• Connect a host to an interface associated with VLAN 99.
• Configure a default gateway.
• Configure a transport input method on the vty lines.
• Remove all access ports from VLAN 99.

Which statement describes SVIs?

• An SVI is created automatically for each VLAN on a multilayer switch.
• A default SVI is created for VLAN 1 for switch administration.
• Creating an SVI automatically creates an associated VLAN.
• An SVI can only be created for the management VLAN.

Which prompt is displayed when a network administrator successfully accesses the boot loader on a switch to recover from a system crash?

• system:
• switch:
• system#
• switch#

What is the first action in the boot sequence when a switch is powered on?

• low-level CPU initialization
• load boot loader software
• load the default Cisco IOS software
• load a power-on self-test program

What must an administrator have in order to reset a lost password on a router?

• a TFTP server
• access to another router
• physical access to the router
• a crossover cable

Which command will provide information about the status of all interfaces including the number of giants, runts, and collisions on the interface?

• show history
• show interfaces
• show ip interface brief
• show running-config